Hello I just purchased the "Video Interface with HDMI for Audi MMI 3G.." I have few questions about the Can-Bus wires.
Am I suppose to splice the can bus wire into the harness?
There are 2 grounds (Batt, 12V), can i combine the ground to 1 grounding point?
My car is 2014 Audi A4 with the MMI 3G+
Thanks
Sunny
Note!
The forum is closed and can be used for informational purposes only. You can read all the information but you will not be able to post on the forum.
If you have any questions related to products, please use the comment section at the bottom of the product page.
Product Question
Moderator: Germes
2 posts
• Page 1 of 1
Product Question
by sunny » 04 Jul 2015, 06:35
- sunny
- Posts: 1
- Joined: 04 Jul 2015, 06:28
- Location: USA
- Car: Audi A4
Re: Product Question
by Chortenia » 07 Jul 2015, 10:14
Hi
As for CAN, please take a look at page 7 of manual http://carsolutions.com.ua/nfs/product/ ... manual.pdf .
As far as Ground is concerned, take it from one place for all devices.
As for CAN, please take a look at page 7 of manual http://carsolutions.com.ua/nfs/product/ ... manual.pdf .
As far as Ground is concerned, take it from one place for all devices.
Best regards,
Car Solutions Team
Car Solutions Team
-
Chortenia - CarSolutions Team
- Posts: 510
- Joined: 17 Sep 2010, 17:06
- Location: Lviv, Ukraine
- Location: Ukraine
- Car: Chery Kimo
2 posts
• Page 1 of 1
Return to Video Interfaces for Audi
Who is online
Users browsing this forum: No registered users and 13 guests